Volt Silverline
A look at what is currently available on eBay
 6~12volt DC Circuit Tester Silverline 3 year Warranty US $4.20 
|
 Silverline 993054 240 Volt 3 Way Splitter US $25.11
|
 Silverline 868864 110 Volt Plug US $10.69
|
 Silverline 457061 12 Volt, 30 LED Inspection Lamp US $40.60
|
 Silverline 634004 12 Volt Trickle Charger US $13.00
|
 Silverline 633728 12 Volt Revolving Amber Light US $15.14
|
 PULS SilverLine SL10 SL10.105 DC 24V/10A POWER SUPPLY 24 Volt 10 Amp Single Phas US $89.99
|
 Silverline 918545 110 Volt Socket US $7.14
|
 Silverline 675308 110 Volt, 32 Amp Socket US $10.80
|
 Silverline 228552 240 Volt Panel Socket US $7.66
|
 Silverline 395002 240 Volt Socket US $7.14
|
 Silverline 794334 110 Volt Panel Socket US $7.97
|
 Silverline 277868 110 Volt Hardwire Socket US $9.26
|
 Silverline 427717 240 Volt Plug US $5.86
|
 Silverline 282604 110 Volt Hardwire Socket US $7.86
|
 Silverline 399015 110 Volt 3 Way Splitter US $25.97
|
 Silverline 282635 8 Watt, 230 Volt Fluorescent Work Light US $15.43
|
 Silverline 427730 13 Watt, 12 Volt Fluorescent Work Light US $28.71
|
Power inverter 1000w 12v to 230 AC keeps beeping and shutting down.?
I have a commercial candyfloss machine that is 950W 220V.
I purchased a caravan leisure battery that is 12v/88AH/ 750 CCA Brand new from an online retailer.
Next i purchased an Inverter (Silverline 1000 w) 230v - 50Hz 1000w Continuous.
I have it all connected correctly the machine turns on, however, when i have to turn up the heat dial on the candy floss machine, which increases the voltage, as soon as it hits 110 volts the inverter starts to make a continuous beeping, flashes up the red low battery light and then shuts off.
The thing is the battery is brand new and so should not need charged and indicates on its screen that the battery is fine.
Do i need to use a higher level fuse in the candyfloss machine (its presently using a 13 amp fuse)
Any advice appreciated.
the problem is your battery if you do not keep it fully charged it will not give full power, a battery has two states resting and in use if your battery is showing 12v resting it will produce 10 volts when used and the voltage will drop slowly till the battery is flat so you must keep it on charge ie keep the car engine running, if not the battery will loose power very quickly and will fall below the threshold required for the inverter causing a low voltage alarm and cut out to prevent damage.one more thing DON'T increase the fuse rating beyond recommended use. just to finish you can't run a candyfloss machine on battery power the wattage is to high..
