Elite Weld
I have a Kenmore Elite Clothes Dryer model no 110.65962401 it is not heating. Everything works but no heat.?
I am trying to clean the lint out of it and am trying to remove the back panel and front panel and have removed all screw and still can not remove the back panel it acts as if it is welded or glued on. thanks!!
RUNS BUT NO HEAT.
PULL THE PLUG AND MEASURE FOR 240 VOLTS AT OUTLET.
IF ONLY 120 VOLTS PUT DRYER BACK TOGETHER. AND CHECK FOR BAD OR 1/2 TRIPPED BREAKER..
IF YOU HAVE 250VAC YOU HAVE A DRYER PROBLEM. BAD ELEM, THERMOSTAT, HI LIMIT
THERMAL FUSE, ETC.
FOLD BACK CONTROL CONSOLE THEN THE TOP THEN REMOVE FRONT PANEL TO EXPOSE ALL OF THESE AND TEST WITH OHM METER..
TO ASSIST VIEW YOUTUBE VIDEOS ON KENMORE DRYER REPAIRS.
(THIS DID WORK OK BEFORE IN IT'S PRESENT LOCATION-RIGHT?)
LOTS OF LINT? TOO LONG OR RESTRICTED EXHAUST DUCT
US $291.00
And a selection of products from Amazon
elite penguin force mission 5:alls weld that ends weld